Page 1 of 1

Nieuw contactslot voor 20 Euro incl. verzend

Posted: Tue Nov 18, 2014 4:15 pm
by oetker
Struikelde vorige week over dit contactslot van een Renault Traffic.
http://www.ebay.co.uk/itm/170802064082? ... EBIDX%3AIT

Geen origineel Neiman mar voor die centen wel interessant.
Image
Image
Image

Precies hetzelfde als een Murena slot alleen het stuurslot is een paar mm langer.
Image
Image
Image

Met een beetje geduldig prutsen kun je dat overzetten.
Image
Image
Image
Image
Image

Rood is + en de gele in dezelfde stekker is starten.
Image

De gele in deze stekker - + contact.
De gele met het streepje geeft + bij contact aan maar schakelt af tijden starten.
Image

Na de ombouw even getest in de stuurkolom vd Murena.
Image

Alleen het borgpennetje red het net niet helemaal.
Daar zou nog 1-2 mm in de stuurkolom gevijld moeten worden of van het borgpennetje.
Image

Al met al een fluitje en goedkope oplossing voor een nieuw contactslot.
Normaal tussen 120-150 Euro.

Herman

Posted: Tue Nov 18, 2014 11:15 pm
by murena81
Herman, jij kan ook echt alles.

Zeer goede tip weer!

Posted: Tue Nov 18, 2014 11:46 pm
by oetker
Alles is een groot woord, maar ik probeer nog wel is wat.
Dat lukt soms wel en soms ook niet.
Hert houd me van de straat :)

Herman

Posted: Thu Nov 20, 2014 10:55 pm
by maxderoswell
Some questions:

Is it possible to fit the traffic wire's on the contactslot from murena (genuine are undersized).

For the problem of alignment, is it possible to cut a little piece of the lock ?

Finally, this solution can be 100% working for bypass the original matra part ?

Mathieu

Posted: Thu Nov 20, 2014 11:49 pm
by oetker
The wires of the traffic are undersized to.
We already using the 100 Amp relais so the lock only has to do that relais and the starter solenoid..
http://www.matramania.be/phpBB2/viewtopic.php?t=2237

The allignment is not a problem.
Th bolt that hold the lock is in the right place.
The pin only need a bit of grinding to fit.(about 1 mm)

The solution is 100% working.
1 wire is not used (see my measurements).
Red=+ goes to red wire Murena.
Yellow next to red wire goes to small grey wire for starting.
Yellow with stripe not used.
Yellow next to yellow with stripe goes to thick grey wire.

Herman